So the poppet valve is on the starboard side? I'll take a picture tomorrow.
I took the lower unit off to look at the water pump/impeller - it needs replaced. But I had a question about my missing "engine rotation compensation fin". In a YouTube video for "Impeller Replacement - Mercury 150...
I took the housing off where I thought I'd find the thermostats and find no thermostats. And it doesn't look like it was intended to house a thermostat. Does my engine not have thermostats or are they elsewhere?
She still doesn't pee water so I guess the next step is to look at the...
I can't find my water intake (inlet)?
Here's a pic:
It's very different from every other XR4/Magnum II I can find on the internet which shows water muffs where I would normally expect the water inlets to be as shown in this photo I got from a YouTube video:
As you can see, I don't have...
I took the plastic throttle linkage off the 3 carbs to remove and clean each carb - engine now runs but idles way high. I know I didn't get this plastic throttle linkage on correctly - probably have the throttles cracked open.
I notice it's slotted where the bolt to connects it to the...
I have the engine in the title (Mariner version) that won't start. Originally it had no spark and I traced that down to the CDI switch modules (both had no spark). Verified trigger was good with an oscilloscope and stator was good. Just got new CDI modules and not I have spark. Now the...
I have a Mariner Magnum II 150 / Merc XR4 2.4L that doesn't have spark in any cylinder. The trigger wheel and stator ohm out to spec. I've verified with a scope that the trigger wheel is good and the stator is outputting the correct voltage; it appears that both CDI Switch modules are dead. I...