Logo
FULL SITE MENU

Recent content by tdrudd87

  1. T

    2002 Yamaha 150HP OX66 - No trim down from throttle only

    Guys, Back with a weird problem. Had the boat out a few times this year. Tonight, halfway thru the cruise, the trim down from the binnacle stopped working. Sometimes it clicks once for half a second, but mostly no response. Up on the binnacle responds fine. Up AND down work on the side of...
  2. T

    AQ200 -AQ250 Female U-Joint Yoke Swap

    To those that remember my prior thread, I'm in the process of swapping a AQ250/AQ275 drive leg onto an old 1960's AQ120/200 powered boat. My current engine has the very coarse PDS splines that engage in the female yoke of the u-joint assembly. The donor leg has the newer fine splines. Mine My...
  3. T

    AQ120/200 - AQ200 Drive input yoke repair or replacment drive options?

    Hello all, I have a 1967 16' runabout powered by the Volvo AQ120/200 drive. This is the Volvo B18 4-cyl driving the AQ200 leg, the precursor to the 250-270-280 drives. I'm towards the end of a 8 year restoration on the boat, and just fired the engine again for the first time. That having gone...
  4. T

    1988 Mercury 25HP Bogging - Misfire

    Hello all, Recently purchased a boat with a 1988 25hp Mercury, serial 0B254011. Runs great for a few minutes, then bogs down to a VERY reduced power level. Rough idle, only reaches 5-7mph at WOT. Cleaned plugs on the water, didnt help. Randomly ran good for 2-3 more minutes, and then repeated...
  5. T

    Volvo timing gear oiling plug

    Gentlemen, I'm back for some help. I am going to be reassebling my volvo b20 next weekend, and am concerned that I have lost a oiling fitting when the block was sent for cleaning. It is the small brass bit that squirts oil on the timing set, item 11 in the attached picture Does anyone know...
  6. T

    AQ200 Drive Parts, Seals

    Hey guys, new thread to clear up confusion. I have a AQ200C DRIVE, powered by the 120hp B18. Packaged as the AQ120/200. This drive is from before the 250+ series drives, so part numbers are hard to come by. Does anyone know the P/N's for the: Rubber cushion rings that seal the bellhousing...
  7. T

    Restoring AQ120/200

    Hello everyone, Got some great advice last year, and I'm back! I'm going thru rebuilding my AQ120/200 with a B18 that is now a B20. Is there a source for brass freeze plugs for this engine? If not, are standard ones OK in freshwater? I removed a "C" gring cam. Is this an acceptable...
  8. T

    AQ120200 Removal

    "Hello everyone, I'm w "Hello everyone, I'm workikng on removing to rebuild the engine from a AQ120/200. I purchased Seloc's online access and it does not contain this particular drive. What is the best procedure to remove the engine from the boat? The drive will come off later for...
See more
Back
Top