Am going to buy a new set (4) of ST 205/75/14R tires for my trailer (hauls a 1978 21 foot Glasply with VP 170 inboard and Honda 9.9 kicker). The choice of available tires brands out there is huge and the variation in prices extreme. Probably all from China and pretty much the same quality...
After starting how long should it take before engine begins spitting. No spit after 1 minute of running in tank. Water intake well below surface of water in tank. I shut it down after 1 minute. The overheating alarm didn't give alert of any problem.
Thanks,
Mark
What is the purpose of the drain port located in the transom shield just to to the right of the steering yoke (see picture)? Outdrive is a 1978 AQ280. Is something wrong if the amount of water being expelled is fairly substantial?. I recently replaced the exhaust bellows - other than...
What is a good, easy to follow, written source of general fix-it guidance for a 1978 VP AQ 280 outdrive? I’m about to replace the U-joint bellows. Youtube and SELOC are not too helpful.
Thanks,
Mark
Hello
What is the correct way to adjust the idle on my 9.9 Honda (remote cable)? It starts and runs at an RPM too fast to shift. It's on a 2010 Hewes 1800. Was doing good when I parked it (covered in carport) in 2015 but on firing it up today I can't get it to idle unless I physically pull...
Hello,
Need to replace the exhaust bellows on my 1978 model AQ280. Stamped number on the current rotten bellows is "Volvo 897631". Yesterday I picked up a new-in-box VP kit from a supplier near Seattle. The kit box is stamped "Kit VOP 876631". Additionally the box label lists the bellows as...
Good afternoon,
What is supposed to keep the oil cooler water intake pipe seated into the oil cooler casting? The previous owner cut the copper intake pipe leaving only a snub of pipe which is connected to a hose. The only thing holding the pipe snub in place is a mess of sealant globbed on...
I was recently given a sailboat with a 1988 Yachtwin 8 HP kicker - Model E8SRLCDE. It starts and runs well. Two questions: (1) How do I kill it? The only way I can stop it is to choke it down as I don't see a kill switch and it keeps running with the throttle full to the right. (2) I'd like...
Ricardo,
I bought the 2004 4.3 and have been getting much guidance on how best to link the engine to the 1978 AQ170. The 1st picture is of the 170. The 2nd picture is of the “new” engine. I’d appreciate some clarification on what is going to be required to convert the 4.3 to be fresh...
Hi,
I bought the 4.3 (2nd picture) and am getting a variety of advice on what I need to link it up to the AQ280 outdrive.
Will I need to change the bell housing?
Will I need to change the manifolds and the risers? Or just the risers?
Do the manifolds change though the years for the 4.3 series...
Good afternoon,
I have a 1978 21 foot Glasply with a Volvo Penta 170/280. The current setup runs good but has over 2300 hours. I may have a chance to buy a low hour 2004 4.3/280. Will this repower (swap entire engine and outdrive) be a major job to do or have done? I assume motor mounts...