Logo
FULL SITE MENU

Recent content by sgruebs870

  1. S

    1960 Johnson 10hp Prop Shaft Seal????

    Hello. I have a 1960 QD-61 Johnson 10hp outboard that has a bad prop shaft seal. I went to the local marine shop and purchased the prop shaft seal that is suppose to fit my outboard, but it doesn't. It fits around the shaft, but is too small for the housing. I cross referenced the prop shaft...
  2. S

    Can my 6hp Evinrude LS tiller be converted PLEASE HELP

    "Hello everyone, I have a ques "Hello everyone, I have a question that I despeately need answered. I'm curious if my 6hp Evinrude LS tiller can be converted to accomidate throttle and steering cables and maybe electric start (electric start is not a big deal though)? I purchased a 6' x 14'...
  3. S

    How do you fill lower unit Sea KingClinton 35hp

    I bought a Montgomery Ward Sea I bought a Montgomery Ward Sea King (Clinton Engine) 3.5hp and am wondering how you flush and fill the lower unit? Is it pretty self explanitory? Any help would be greatly appreciated. Thanks!!!!
  4. S

    72b Johnson 65hp Push Button Shift Conversion

    "I have a 1972 Johnson 65hp ou "I have a 1972 Johnson 65hp outboard with an Evinrude 3 button shift switch (R, N, F). The switch has gone bad and I cannot find a replacement anywhere. I heard I could replace it with a 3 position maintained toggle switch. Does anyone know how to do this? Any...
  5. S

    1986 Johnson 15hp trouble running at full throttle

    "I've got a 86' Johnso "I've got a 86' Johnson 15 hp outboard that won't stay running when I open up the throttle. I replaced the fuel pump along with the impeller this fall just before duck opener. It starts just fine, but when I give it full throttle it bogs down and dies. Does the carb...
  6. S

    1972 Evinrude 65hp wonbt shut off HELP

    "I have a 1972 Johnson 65hp th "I have a 1972 Johnson 65hp that won't shut off. I turn the key to the off position and pull it out and it just keeps on going. It starts and runs like a top. I'll start it, turn the key to off, pull it out and it will rev in neutral at low rpms then after...
  7. S

    Hand Pumped Tilt

    "I'm looking for a hand pu "I'm looking for a hand pumped hydraulic tilt for my 72 Evinrude 65 hp outboard. I've seen a few of them around in the past few years, but have never got the chance to get my hands on one. I think they're made by DOLE. Anyone know where I can get one? Any info...
  8. S

    Johnson 15 hp Idle Trouble

    "I'm having trouble geting "I'm having trouble geting my 1986 Johnson 15 hp outboard to stay running at idle speed. The outboard starts fine, revs up, but when I let off on the throttle it runs for about a minute then dies. I checked and I'm getting good spark in both cylinders. I just...
  9. S

    1986 Johnson 15hp Pull Start Assembly Problem

    "I have a 1986 Johnson 15 hp o "I have a 1986 Johnson 15 hp outboard with pull start. The recoil spring broke, I replaced it no problem. When I went to pull start it, it wouldn't pull. I took the cowling off, checked my work and it was correct. I tried loosening the bolt that holds the...
  10. S

    Trouble Starting 1972 65hp Evinrude

    I'm having a problem start I'm having a problem starting my 1972 Evinrude 65 hp outboard. If I spray the tiniest bit of carb-cleaner in the top carb and turn the key it turns right over. The outboard will run like a top and will stop and start right up for several hours after that. If it...
  11. S

    1972 Evinrude 65 hp

    "I'm having trouble starti "I'm having trouble starting my outboard and keeping it running. When/if it starts it stays running in idle speed, but when I hammer the gas it kills. If I SLOWLY accelerate it won't kill and after a few minutes at high speed the boat runs fine. If I idle too long...
See more
Back
Top