Logo
FULL SITE MENU

Recent content by macktack

  1. M

    1980 25hp real hard to pull

    hi all motor runs great,comp. 125 both,pull start,it is so hard to pull what would cause this,thanx
  2. M

    1992 120 wot timing

    hey all i went out today,had to use my tractor battery 12 volt full charge for the timing light,since the batteries are under console,i first static timed in driveway,unhooked the quick start set throttle at wot it at 14 btdc,it calls for 17-19 btdc,so out on water running 5000rpm and set it at...
  3. M

    difference between 120-140 hp

    hi what is the difference between the 2 motors,is it carbs,jets,ports,thanx
  4. M

    1992 120hp t stats

    hi all can someone tell me why the t stats have threaded ends on them,do they screw into something,thanx
  5. M

    prop shaft seals 92 120hp

    hi all,what would i do to replace the 2 seals,how hard is it,thanx
  6. M

    compression cold and warmed up 1992 120hp

    hi all does compression # change when motor is hot or cold,i have a 92 120hp rude,i got 125 on all 4 cold,is this good will they go up with motor warmed up,i havent run it yet im putting carb kits in an water pump,t ststs,thanx
  7. M

    1994 200hp drain valves

    hi all im rebuilding motor,replacing drain elbow fittings,do they press in,thanx
  8. M

    Modifications for water passages 93 and up

    hi all does anyone know about these cooling passage mods for 93 and up 185 through 250hp loopers,per Mar Fab,also say water deflectors should not be replaced ,use substitute
  9. M

    flywheel puller bolt size

    hi all,225hp need to know size bolts for flywheel puller,thanx
  10. M

    cyl.bore and sleeve

    hi all does anyone know where i can get one cyl. bored and one resleeved,the other 4 honed i want to rebuild,what kind of cost would the cylinder work run thanx
  11. M

    25"transom

    hi all,i have a 25" boat transom,20" motor what are my options,jack plate,bracket any? thanx
  12. M

    85 140hp looper lower unit 25"match up

    hi all does anyone know which lower units will fit,85 140 25" thanx
  13. M

    1983 150hp evinrude

    hi all,was givin a 150 25" shaft runs great,compression 107-110 all 6,are these good motors,thanx
See more
Back
Top