97 150hp v6 carburetor.
Motor was blown when I bought it.
I rebuilt this motor myself using manual.
4 pistons and cylinders were fine.
1 cylinder was bored out next size and I used a new piston for this.
1 cylinder destroyed and sleeved to std size I used a good used piston to replace.
New...
Just picked up a deluxe lite twin minn mpls USA fairly cheap
With the intent to fix up.
Anyway, the guy selling these OLD motors on Craigslist
Phoenix boat parts/boats cat. Anyone looking for some really old
motors should look this up. I think you can get them CHEAP.
I want to add a kill switch to this motor since it did
not come with one and wanted to make sure I wire
it correctly. Do I just add the two wires from the switch
to the two ignition wires? Then flip the switch and it's
a start/stop mode?
Picked up a elto what I think is a 3hp 1940 4357-05903.
Paid just a few bucks so I'm going to play around with it and see if I
Will run. Clean and solid no rust or dirt. Decals almost gone.
Anyway any parts out there for these motors?
Any hidden traps regarding these old motors?
1997 Fisher fish and ski. I'm trying to cleanup the old wiring.
There is a small 2 inch long 1 inch dia. cylinder electronic component wired to the ignition switch. Any idea what it might be? Do I need it?
There's another one kinda like that next to it wired to a switch. What could it be? Do I...
Mine stopped working so I'm trouble shooting to see what's
going on. Are the SLOTS for these lights always hot or does
the power come from when the key is turned to on?
I want to run some evinrude engine tuner thru this 3.9hp
just because it's probably never been done before. With the
engine running can I remove the engine cowl without
jacking things up?
Anybody have info where I can find a jr static timing video for
97 150 hp carb 2 stroke. I have the written instructions but
Would like a visual if available.
I have a brute 756 that came with a boat that I bought. There are
2 batteries one on the left and one on the right hand side of boat.
The trolling motor only works on the 24 volt switch. Does not work
at all when on the 12volt switch.
I'm assuming the 12 volt part of the switch is faulty.
Is it...
Been looking for a MERCURY service repair manual with no luck.
I have seen plenty of parts manuals but no repair manuals.
Does ANYBODY know if their ever was a repair service manual
For this motor? Mercury that is. 1965 - 1968
Wanting to change the TOP oil seal vertical drive shaft
just above the impeller. I measure the shaft dia about
.45 and dia of old seal about .84.
Parts list calls for #38 serria i.d seal at .500 (this would
not fit) .45.
However, #29 seal numbers look correct for what I
need.
Oem mercury does...
Old man gave me a free sears 7 clutch shift
217-58870
203482
He said it ran perfect last time he used it.
It's been stored upright in his garage for the last 30
years. Very solid clean. I figure it's a 1970's and there's
probably no parts availabe. I'm going to tinker around
With it and see if...
Recently rebuilt my 1990 60hp and to date it starts right up and runs
fair.
Now I'm trouble shooting to get it to run perfect. My carbs did NOT
have NOZZLE WELL GASKETS when I was cleaning them. Also
my carbs do NOT have a slow speed adjusting screw even though
the PARTS list show a nozzle well...