Logo
FULL SITE MENU

Recent content by am_dew

  1. am_dew

    Any E10 (Ethanol) problems you are aware of on older engines?

    I've used 91 octane fuel here in the USA forever on my AQ130C, which does contain ethanol per the sticker on the pump, and have never had an issue. I do add a can of SeaFoam to the fuel every other tank, so that may be a factor.
  2. am_dew

    New Dist

    Just the Pertronix conversion kit. The distributor in mine is the OEM Bosch that is going strong after 51 years. In fact, since installing the Pertronix kit 17 years ago, I have not checked/adjusted the timing more than a few times and the engine runs great all the time.
  3. am_dew

    New Dist

    I'm lucky being in the dry air of central Northern California.
  4. am_dew

    New Dist

    Not to argue, and call me lucky I guess, and I am sure it varies depending on how much you use the boat, weather conditions, etc. but I've gone at least 5 years, without replacing my cap or rotor on my AQ130C with Pertronix ignition with absolutely no issues.
  5. am_dew

    Neutral safety switch for 270 drive?

    Thanks. I would have no idea how to hook it up though.
  6. am_dew

    Neutral safety switch for 270 drive?

    Thanks Capt. Do you know of a part number that I can check out? Or maybe the specific kind of microswitch made by DigiKey or Mouser?
  7. am_dew

    Neutral safety switch for 270 drive?

    Is it possible to add a neutral safety switch to a 270 outdrive paired with an old-school side mounted Morse controller similar to the one in the attached pic? Or do you have to replace the entire controller? After 20+ years of owning this boat, while I always check to be sure the throttle is...
  8. am_dew

    270 outdrive slippage?

    Thank you Ricardo and Capt Bob. I may have previously drawn a line across the hub/face of the prop so I will remove the prop and check to see.
  9. am_dew

    270 outdrive slippage?

    Yea, I know about doing that and will do. Luckily, if it slipping, the prop I was using is a lower pitch than the prop I normally run with because we had 4 people in the boat this time.
  10. am_dew

    270 outdrive slippage?

    Thanks. The fact that my boat performed normally for the next 15 miles tells me that the hub was not causing any prop slippage, or can the slippage be so minimal that you would not notice it?
  11. am_dew

    270 outdrive slippage?

    Yesterday, while on plane in my 17' v-hull runabout while cruising through some areas that had clumps of floating grass in it, suddenly it sounded like my prop slipped. I immediately backed off the throttle and turned the engine off, the raised the outdrive to check and see if any grass had...
  12. am_dew

    Adding neutral safety switch for 270 outdrive?

    My 1972 runabout has the AQ130 engine and 270 outdrive with the vintage style shifter (Teleflex?). Is it possible to add a neutral safety switch to it? I am guessing not since the shifter is strictly mechanical with no wires or connectors.
  13. am_dew

    AQ130C: Water in oil

    Thanks Bob. I drained off a little more oil after letting it sit overnight and that oil looks good. So, I am guessing the first sample contained what little water was left in the pan. I am going to take the boat for a cruise while closely monitoring the oil at the dipstick and hope for the...
  14. am_dew

    AQ130C: Water in oil

    Forgive the long post. This is for my Volvo Penta AQ130C four cylinder push rod engine, which was discovered to have water in the oil a few months ago when I went to do the annual oil change. Water in Oil Engine had not been run since was worked on by a mechanic last Fall to resolve an...
  15. am_dew

    AQ130C and stuck oil filter

    As part of my spring maintenance after the boat being not used since early October 2021, I was going to change the oil and filter. However, the oil filter is not coming off. I have tried a standard oil filter strap type wrench as well as two different flute cap style wrenches that you use with...
See more
Back
Top