I just got finished (well almost) with servicing complete outdrive. Of course dash trim indicator was not working, installed new trim senders on outdrive,one set of the 2 wires were just hanging on transom wall the other 2 were plugged in to the wires next to the trim pump,not good at all...
this is a new follow up thread to my previous inquire.99 model alpha 1 gen 2 drive,2 seals that go in the upper part of shaft,which direction do the press or tap in,I do know the brass bushing bottoms out on the top where shift bar connects, but unsure how seals are placed. It does seem they...
whats the process for removing the bellhousing upper and lower shift shaft bushings on alpha 1 gen 2?
also to install are they pressed in or can they be tapped into place?
1999 Baja Sidewinder 305 V8 thundebolt V alpha 1 gen 2 1.62 ratio
close to starting the DIY procedure on shift cable,gimbal bearing and bellows replacement. I have all OEM parts and tools to begin. My boat has thru hull exhaust, which means I have no exhaust flowing thru prop. Is there any...
1999 Baja Sidewinder 305 Alpha 1 Gen 2
My boat is factory equipped with individual throttle and shift levers.
Shifting into forward or reverse is like its between gears grinding.
It will go into gear after shifting from reverse into neutral and vice versa.
Do I need to adjust the shift cable...
99 baja sidewinder with 5.0 litre,original motor and trim pump,noticed water in my trim reservoir, very milky looking, in and out trim works fine but I am sure this is a problem. suggestions of where I should start to fix would be greatly appreciated.