Hookinpigs
New member
I noticed a factory groove below pin hole on the DS.
Is this where the inside diameter of the rubber seal suppose to ride ?
I did a psi ( 9psi ) test with a bucket of water and found bearing housing gasket leaking.
I took it apart for a redo and noticed the groove on the driveshaft.
Thanks.
Is this where the inside diameter of the rubber seal suppose to ride ?
I did a psi ( 9psi ) test with a bucket of water and found bearing housing gasket leaking.
I took it apart for a redo and noticed the groove on the driveshaft.
Thanks.