I am in the process of swapping out a 4.3 l to a 5.0 in a 2004 Sea Ray 200 sport (Previous Owner didn't winterize). Im in the process of fitting up the accessories from old to new engine. How tight a fit is the bell housing on the dowel pins coming out of the block? I have approx 1/16" play, which seemed loose. It was my understanding that the 4.3 and 5.0 used the same bell housing (original 4.3 Serial # is OM491962, replacement 5.0 is newly purchased partial engine from Michigan Motorz - GM base motor).
Is this incorrect that it should fit ok?
Thanks for your help
Is this incorrect that it should fit ok?
Thanks for your help