Logo
FULL SITE MENU

Wire harness for 59 evinrude motor

B

baddog

New member
Would anyone know where I can

Would anyone know where I can purchase an external wire harness (loom) for a 1959 evinrude/lark motor model # 35516 Thank you
 
"Bryan, Those harnesses are no

"Bryan, Those harnesses are not too complicated, or at least don't need to be. You could make one up. I do not know what motor you have, but the largest motor of that year was the 50HP V4. It had wires for +12V, Ground, starter solenoid, elec choke, and magneto killer wire. There were wires for an ammeter, but a voltmeter is better and can be run off the +12V wire. The 50HP did not have an overheat wire, but the 35HP twins did, I think. So you need 5 or 6 wires, a SPST switch for ignition and two pushbuttons(choke, start) and a hot light and you have a complete harness. This of course presumes you have the external starter solenoid box, or can make one up."
 
"Brian, One more thing. Those

"Brian, One more thing. Those motors are negative ground (earth)"
 
Back
Top