Logo
FULL SITE MENU

What part is this called and where to get a replacement for a 60hp evinrude 2 stroke

S

sasfish

New member
1000002675.jpg
1000002676.jpg
 
The cracked part is called a ---GUIDE ----If in Canada-----evinrudeparts.ca-----may help you.----Do you know someone with a 3D printer?-----And I think I would repair that part somehow.-----What is your motor doing / not doing ?
 
Last edited:
Thank you we have now ordered one. But would you know how to adjust the idle speed when we have 3 carburettors cause running a little rough on low speed
 
Step #1 is a compression test.----Post the actual values here.-----Carburetors normally do not go out of adjustment.----So careful if you decide to adjust things.
 
So when we at full throttle after a a little bit we loose power not sure why as all fuel lines tank and fuel filter is brand new. Not sure what causes this
 
Not 100% sure your motor has it , but it is a safety system ---SPEED LIMITING OVERHEAT WARNING ----Prevents motor running at full power to possibly prevent engine damage.-----Motor should have water pump impeller replaced about every 5 years.----
 
It is NOT an adjustable jet.---See post #5 again.----Do the compression test and post the actual values.----Buy / borrow / rent a compression tester.
 
Would this be a 1992 model as we dont have the plate on it for the serial number it a 60hp 2 stroke. I'm not sure if this helps

1000002705.jpg
1000002704.jpg
 
Back
Top