Logo
FULL SITE MENU

Vro disconnectiontemp alarm

P

piperdog

Member
"hello,is it as simple(on

"hello,is it as simple(on the electrics side )just to disconnect the two wires from the oil tank ,reason being ive changed the thermostat and it still beeps ,can using flushing muffs make any differance from being in the water...thanks tony

1988 ,v4 90 hp evinrude"
 
"The wires on the oil tank are

"The wires on the oil tank are the low oil warning. That's a beep every 20 seconds or so.

A continuous tone is overheat. An on/off/on/off tone is VRO no oil.

Before you tear out the VRO, make sure that's actually the problem. Is there oil in the tank? Is the line in good condition with no air leaks? Is the pulse hose in good condition and secure. If the VRO isn't pumping oil properly, chances are it's not pumping gas properly either. Change the whole thing instead of just disconnecting the oil and wire."
 
"i just had one,that the elctr

"i just had one,that the elctronics,were bad,on the VRO..seen it,but not a common prob..as soon as u turn key on,..horn sounded...disc,and gone,..but,..he has no ..'no oil' warning...advised to get off of oil system,..or maintain it..."
 
Back
Top