I recently changed my drive shaft bellows and noticed .050" play(front-back an d up,down, left, right) in the drive shaft. I plan to replace the PDS bearing and purchased new U joints as well. I am noticing a growling and vibration while making hard turns above 15MPH. I suspect there may be a U joint issue as well from reading other posts. They appear to be OK from the outside and feel tight.
Is there any way to inspect and/or replace the U joints without getting too complicated? I have read several post concerning "rolling torque values", shims, and crush sleeves. I do not have the workshop manual for this drive and all other post I have found are regarding slightly different drives.
Any help would be greatly appreciated.
Thanks, Jason.
Is there any way to inspect and/or replace the U joints without getting too complicated? I have read several post concerning "rolling torque values", shims, and crush sleeves. I do not have the workshop manual for this drive and all other post I have found are regarding slightly different drives.
Any help would be greatly appreciated.
Thanks, Jason.