volvo 270 out drive

[djah]

good evening ive been looking allot on these forums lately and now i thought it was time to ask my question,

so since last year i am the owner of a *old* glastron bayflite from 1981 ( i think it is that year haha ) anyway it has an inboard volvo penta b20 aq130 with a 270 stern drive,
now when i am going at low speed the sterndrive is going from left to right etc...
i found out that the steering bushing is wearing out allot in these type of stern drives ,
my question is or there is any site where i can order these ( since at the original volvo penta shop in the netherlands these are not available anymore )

i hope that u can read my crappy english and hope some 1 could help me out

Greetings Djah

 

[djah]

897731 and 832652 I believe are the part numbers for the yoke bushings. New bushings for the helmet would help tighten it up also does the center pin have two bolts holding it in?

my rod is holded by 1 bolt and as far i found out is that there are 2 different types of steering rods a thick and a thin 1 me myself have the thin 1 and here are the plastic bushings in

 

[RicardoMarine]

The 250 and 270 collar steering fork shaft is small diameter... 275, 280, 285 are larger diameter.
I would not be surprised if the two bushings are no longer available for the 270.

This will take you to the 270 drive connecting components.
Doesn't matter which engine..... the collar steering fork bushings for the 270 were all the same.

http://www.marinepartseurope.com/en/volvo-penta-explodedview-7736850-44-12893.aspx