I have an Alfa1 unit. Replaced the trim limit switch on the port side. Was easily able to set the correct distance of the up trim and locked the sensor down.
Ran unit up, then down. On every up/down cycle, the lenght of my setting keeps getting shorter and shorter. Instead of 20 or 21 3/4 inches I eventually end up with maybe 1".
The alignment marks were correct.
Out of ideas. Anyone?
Thanks for any time or advice you can extend me.
Ran unit up, then down. On every up/down cycle, the lenght of my setting keeps getting shorter and shorter. Instead of 20 or 21 3/4 inches I eventually end up with maybe 1".
The alignment marks were correct.
Out of ideas. Anyone?
Thanks for any time or advice you can extend me.