falgranado
New member
Good evening fellow boaters!
I was trying to do regular maintenance on my 1999 Jhonson 115 and during the removal of the lower unit process I trimmed all the way up, however during this process When I finished removing the lower unit , I tried trimming all the way down, but it would do anything, so I used the manual relief valve and positioned mid trim, when closing the manual release valve, the motor would trim normally (a little slower when trimming down). Would you think is low fluid level or something else?
I was trying to do regular maintenance on my 1999 Jhonson 115 and during the removal of the lower unit process I trimmed all the way up, however during this process When I finished removing the lower unit , I tried trimming all the way down, but it would do anything, so I used the manual relief valve and positioned mid trim, when closing the manual release valve, the motor would trim normally (a little slower when trimming down). Would you think is low fluid level or something else?