richard_bar
New member
"I screwed up reassembling the
"I screwed up reassembling the tilt/trim sending unit on my 290DP-B, I should of read the instructions better. I guess I indexed the gears on the steering helmet wrong...after all was said & done the readout was -88 and would not change at all, while rotating the gear (I think I just rotated it way too far one way). I bought a new sending unit and installed it, this time following the manual to a t. The read out worked fine for a few cycles then went to a reading of -88 again, frustrating
anyone have a clue what is going on ?"
"I screwed up reassembling the tilt/trim sending unit on my 290DP-B, I should of read the instructions better. I guess I indexed the gears on the steering helmet wrong...after all was said & done the readout was -88 and would not change at all, while rotating the gear (I think I just rotated it way too far one way). I bought a new sending unit and installed it, this time following the manual to a t. The read out worked fine for a few cycles then went to a reading of -88 again, frustrating
