Logo
FULL SITE MENU

Tilt and trim 1984 70hp jonhson

L

Laird Reuter

Guest
"When using trim switch there

"When using trim switch there is no reaction, switch is good and the relays are new. Suspect no electrical power at trim switch. Where is the main power source for this? If anyone one has a wiring diagram for this could you please e-mail this to me. Thank You"
 
"Mine gets its 12v feed from t

"Mine gets its 12v feed from the battery to ignition switch lead. (The terminal on the ignition switch which goes to the battery, hot all the time) The last time I had this problem, I found the screw on that lead was loose. Turns out they all needed to be tightened. Eliminated lots of interesting intermittant problems I had had."
 
Find out if the trim/tilt moto

Find out if the trim/tilt motor is faulty.
Disconnect the cable from the trim/tilt motor and use jumper cables directly to a battery.
Robert
 
Back
Top