Logo
FULL SITE MENU

Suddenly dies 1996 25 hp

P

prestonbreen

New member
I have a 96 25hp Evinrude that will suddenly die when I'm cruising at a good speed. It doesn't seem to do it at a lower speed. After it dies it's hard to get it started.
 
First thing to check is the ta

First thing to check is the tank venting. Try taking the tank cap off
 
"Does the fuel primer bulb hav

"Does the fuel primer bulb have a tendency to be drawn flat?

(Point Setting Of Magneto Models)
(J. Reeves)

Set the points as follows. Have the flywheel key aligned with the fiber rubber portion of the ignition points. Adjust the gap so that a .020 gauge will pass thru but a .022 will not. Should there be any question of the points being dirty (touching the contact with your finger would cause them to be dirty), clean them with a small brush and acetone or lacquer thinner.

NOTE: Should the operating cam have a small portion on it with the word "SET" imprinted, align this portion with the fiber rubbing portion instead of the flywheel key.

Thousands of parts in my remaining stock. Not able to list them all. Let me know what you need and I'll look it up for you. Visit my eBay store at:

http://stores.ebay.com/Evinrude-Johnson-Outboard-Parts-etc?refid=store"
 
Preston your motor doesnt have

Preston your motor doesnt have points on your model. Check the primer bulb as joe says also do you have to prime the bulb up to restart the engine if you do it could indicate a fuel pump prob
 
Back
Top