I am changing the fuel filters in the Fuel Control Cell for the first time. So of course I change the starboard one first because it is easily accessible and this is my first time doing it. Well it was a piece of cake. 10 minutes and I was done. So I am confident now and move over to the port side motor which is tucked in the corner in the engine compartment. I get the oil filter wrench on the canister and start pulling. I got good leverage from the angle I had too. I was pulling so hard I was afraid I was going to break the bracket. And tricks for getting these canisters to break free? Can't really use penetrating spray as it will just drip down.