Logo
FULL SITE MENU

Replace Bearings between Engine and Unit

F

fasteddie

New member
"the bearings are locked up I

"the bearings are locked up I need a diagram or some info on what side to take apart first, and where can I get replacement bearings
OMC Drive System, Inboard
Model # J828503
Ser # 552STHRCOM
where could I find this, can you supply any help?
thanks,
ED"
 
"Ed,

Are you sure about tha

"Ed,

Are you sure about that model number? Could it be 502STHRCOM instead? Is it an 8.2L ?

See this page and the following pages... but I think the model number you have entered might be incorrect, so I'm not sure what you have."
 
"Andrew, you are correct I tra

"Andrew, you are correct I transposed two of the numbers the model # is actually 252STHRCOM
sorry about that my bad.
thanks for your help in advance.
ED"
 
"you can get replacement brgs

"you can get replacement brgs at any brg house if you take the old ones in or the timken numbers off them. The ballgear shaft and brgs all come out the rear of the intermediate. seals too. But unles you have the proper tools to do dimensional preloading of the new bearings, you'll still have to pull the engine so you can set up the new tapered roller bearings using a rolling torque method. You need a service manual. Click "engine manuals" top left of this page to get a Seloc book, or look for an OEM manual on eBay."
 
Back
Top