Reed Valves

[solarman]

Does anyone know the part number for the reeds for a 1966 Evinrude/Johnson 80hp? It doesn't show them on the parts diagram shown on this website.
Thanks

 

[fdrgator]

Actually, it does show it. Part number 379571, in stock.
http://www.marineengine.com/parts/j...anufacturer=Evinrude&section=Carburetor+Group

 

[solarman]

It doesn't show just the reeds. #15 shown is the plate which includes the reeds. I have some gaps on mine. I saw in another post that the gap can't be more than.002, is that correct? Also, said they can't be flipped over or bent?
Appreciate any advice.
Thanks

 

[kimcrwbr1]

There are a bunch on eBay for around $20 each the reed blocks come complete with the leafs. 0379571

 

[racerone]

Reeds that are open a wee bit are NOT a problem.-----What is your motor doing / not doing ??

 

[Boobie]

Good question Racer, why does he want the reeds ??

 

[kimcrwbr1]

I don’t have the specs but the leafs can be closer to .007 open before they need replaced. Have you checked compression? Those older engines can develop leaks in the bypass cover gaskets or crank seals. Especially if a overheat occurred?

 

[solarman]

I'm tearing down one to rebuild and thought if available I'd just replace the reeds.

 

[racerone]

The reeds are very durable and rarely need replacement.----Save those pennies as you may need a bundle of money for piston rings.

 

[racerone]

Tear it down and inspect everything BEFORE spending any money on parts.----The reeds are very durable and rarely need replacement.----Save those pennies as you may need a bundle of money for piston rings.----Rings are about $50 a set and you would need 4 sets.

 

[joereeves]

I'm tearing down one to rebuild and thought if available I'd just replace the reeds.

Those things last forever (almost!).

Unless a piece broke off, one got bent bad somehow, or your dog tried to eat it..... reuse them.