Logo
FULL SITE MENU

Rebuilding a 1973 Evinrude Mate2

M

mikes1canoe

New member
Hello to all.
This is my first time posting, but I've been reading the odd one here and there while working on a very new project. I've jumped in with both feet rebuilding a 73 Mate2, acquiring parts and gasket kits for this wonderful little motor. But I'm having trouble locating the upper crankshaft seal, apparently it is obsolete. Does anyone know of a supplier or a comparable seal that would work?
Model #2302B
 
Thanks racerone, a local dealer had one so finally I have all my parts. Spent yesterday putting her back together, but taking my time. However, I was discouraged to find a hair line crack along the bolt hole on the power head where the intake manifold mounts. I suppose three out of four is okay?
 
I was thinking about that too. When I was talking to a friend at work today he said that his stepdad might be able to weld it. He's a welder by trade and has worked with aluminium before.
 
I have a "parts motor", if you need anything.
Upper crankshaft bearing failed...too much trouble to rebuild.
It had lost compression at one time...hole in the head gasket.
 
You cannot weld that part as aluminum has no memory it will warp and the crankcase halves will not match up. I would JB weld it and then see if it leaks. just spray soapy water there while running and look for bubbles.
 
Happy New Year! With the passing of the Winter Solstice and each day growing longer, I'm looking forward to pulling out from hibernation my little Mate. But I still haven't found the extension kit needed to obtain enough depth while on my canoe.
Is there anyone out the whole might have one not being used or know of someone? I would really appreciate any help.
Cheers.
 
Back
Top