commuter64
Contributing Member
Me again
this is my boat set up https://www.marinepartseurope.com/en/volvo-penta-explodedview-7736260-44-12586.aspx
This is my set up with a Sierra hose. The ridge bead on the hose (about 1/4") seems too much.
will not allow the mating surfaces to fit flush. Do I have the wrong hose? If I were to use washers Between the female thread mating surface? It's a shame I tossed the old hose so i could compare! Ugh.
Thoughts??
this is my boat set up https://www.marinepartseurope.com/en/volvo-penta-explodedview-7736260-44-12586.aspx
This is my set up with a Sierra hose. The ridge bead on the hose (about 1/4") seems too much.
will not allow the mating surfaces to fit flush. Do I have the wrong hose? If I were to use washers Between the female thread mating surface? It's a shame I tossed the old hose so i could compare! Ugh.
Thoughts??