Logo
FULL SITE MENU

Questions on my 68b 95 Johnson

7

75vette

New member
"My first question is about my

"My first question is about my low speed mixture. It is hanging out of the front of the cowl as if it is definitely out of place. This motor has sat for a long time so i have no idea where to begin as far as this setting? And how do i fix it, i can't find anything that really holds it in place?

My second question is on the release to lift the motor up from the lowest position. i noticed the two hooks that lock on to the pin that sets the position of the motor. Is there a release on the motor somewhere that makes it easier to release?

I searched on my questions and didn't find information to fully answer my questions. Any help is appreciated. Thanks."
 
Start with the Idle screw full

Start with the Idle screw fully inserted and then backed out about 1 turn.
On the motor tilting - There should be a release latch on or near transom screws.. Most are marked "release" Just move it to the unlatched position.
 
"The slow speed knob should be

"The slow speed knob should be fitted to the mixture adjust needle. There should be a bow washer and retaining clip securing it to the starboard side panel
See parts #22, #21 and #25 HERE
and #40 HERE"
 
Back
Top