just bought a 2008 90 HP 2 stroke , tilt trim 13 1/2 x 17 3 blade alum prop, 5500 rpm's wot, after putting boat on trailer last week noticed a paint chip on inside prop blade, no nicks,
did not hit anything etc. repainted spot. yesterday went out, same thing but spot I painted was off and new spot on next blade, all at end of blade toward center.
got spoiled by the I/O's, am I trimming this thing to far and cavitating the paint of or just cheap paint?
did not hit anything etc. repainted spot. yesterday went out, same thing but spot I painted was off and new spot on next blade, all at end of blade toward center.
got spoiled by the I/O's, am I trimming this thing to far and cavitating the paint of or just cheap paint?