RobertArtist
New member
I have a new 318 long block ordered for my 32' Marrinett. I am taking the engine parts in for sand blasting and the guy recommended that I cut the rivets and remove the plenum pan plate, then just tap and bolt it back on.
Would this be necessary? I have Visions s of the bolts falling out.
Also, is there a way to be sure the eng. Circulating pump is good while off from engine? (I have never ran this engine)
Thanks.
Would this be necessary? I have Visions s of the bolts falling out.
Also, is there a way to be sure the eng. Circulating pump is good while off from engine? (I have never ran this engine)
Thanks.