Logo
FULL SITE MENU

Outdrive cable

"And I have a bigger and more

"And I have a bigger and more powerful boat than yours. So what's your point?
biggrin.gif


(Sorry, I couldn't resist)
wink.gif
"
 
sorry i was asking about the c

sorry i was asking about the cable that shifts it from drive to nutrel to revers. when i push the handle forward the cable does not move. but the engine goes up. and it is already in gear when i start it.
 
"Check page 136 (138)

"Check page 136 (138) of this manual for cable adjustment:

http://www.mybayliner.co.uk/boatmad/280285290.pdf

Also, make sure that cable attachment tab (part 28) is not loose, make sure the two screws 29 are tight. Also, make sure the cube (49) is attached tot he cable and the cotterpin 51 is securing the cube into the gear yoke (2).

http://www.volvopentastore.com/INTERMEDIATE_HOUSING/dm/cart_id.657400424--catego ry_id.332885--list_time.1211223211--session_id.455320767--store_id.366--view_id. 324046

Also, make sure the cable(s) have not become loose in the control lever."
 
There should be two cables: on

There should be two cables: one going from the control to the carburetor (gas) and another one going from the control to the outdrive (shift). Which one can you not find?
 
"Remove the cable, then either

"Remove the cable, then either measure it or take it with you as a sample, and get a new one from a marine parts store. Those cables are very common and come in any available length. The length in feet should be stamped in your current cable sleeve."
 
Back
Top