Hey guys I have a 1993 OMC Cobra Sterndrive.
I am going to get in and replace the u-joint bellows, exhaust bellows, gimbal bearing, and shift seal.
I am wondering how much play is acceptable in the u-joints when I get in there?
I pulled the drive earlier this year to grease them and noticed a small amount of slop which went away after I greased them.
If I have to replace them are there any cross referenced u-joints that will work I could possibly buy locally without ordering from west marine or sierra?
Thanks. Chris
I am going to get in and replace the u-joint bellows, exhaust bellows, gimbal bearing, and shift seal.
I am wondering how much play is acceptable in the u-joints when I get in there?
I pulled the drive earlier this year to grease them and noticed a small amount of slop which went away after I greased them.
If I have to replace them are there any cross referenced u-joints that will work I could possibly buy locally without ordering from west marine or sierra?
Thanks. Chris
Last edited: