Logo
FULL SITE MENU

OMC 800 stringer Propeller shaft removal

P

Pacer64

Guest
What holds the shaft from pull

What holds the shaft from pully out of the stern?. I have everthing out snap rings and reverse gear but the shaft is still held by something. Is there a pin that is holding it?
 
"You have hardly started yet f

"You have hardly started yet for that operation!
Down with the lower unit.
Out with bearing house and reverse gear as You obviously have done.
Unscrew pinion nut, upper driveshaft bearing housing, out with driveshaft and pinion.
Off with shift cover (where the cable is attached).
Put the housing on the side and pull out the prop shaft as You at the same time pull out the vertical shift shaft!
Got it?"
 
Back
Top