"Have a 2008 NSD 40 TLDI tille
"Have a 2008 NSD 40 TLDI tiller steer with about 100 hours on it. It runs great, but recently I've had an issue come up that at WOT (5700 rpms) when I trim up the three warning lamps will start to flash. They don't flash at any other speed than wide open and only when I trim up high. It's not the rev limiter as it'll happen about 5700 rpms. The manual simply says take it in for service. My question is what problems does the 3 lights flashing indicate? Is it possibly low water pressure which would make some sense since this is a tunnel boat and the engine starts getting higher out of the water when WOT and highly trimmed. There is a warning light for high water temp, but that isn't lighted when I have the 3 lamps blinking. They stop blinking as soon as I either trim down some or slow down some. Any tips before I bring it in would be appreciated."
"Have a 2008 NSD 40 TLDI tiller steer with about 100 hours on it. It runs great, but recently I've had an issue come up that at WOT (5700 rpms) when I trim up the three warning lamps will start to flash. They don't flash at any other speed than wide open and only when I trim up high. It's not the rev limiter as it'll happen about 5700 rpms. The manual simply says take it in for service. My question is what problems does the 3 lights flashing indicate? Is it possibly low water pressure which would make some sense since this is a tunnel boat and the engine starts getting higher out of the water when WOT and highly trimmed. There is a warning light for high water temp, but that isn't lighted when I have the 3 lamps blinking. They stop blinking as soon as I either trim down some or slow down some. Any tips before I bring it in would be appreciated."