IOnlyGetTheWeirdProblems
New member
I just installed a new impeller, housing, inner housing, housing seal, o-ring, and water tube rubber bushing, but still no water flow. pulled the foot, got out my drill, and tested in a barrel of water. I had it submerged to the level of the pump, still no flow. pulled the impeller housing and double checked the impeller key, it was fine. put it all back together, tank tested it again,,still no flow!<br> this motor had been badly overheated, thermostat had to be cut out, as it was melted into a glob. i have not replaced it yet but the gasket and cover seem to be all right. motor fires right up and runs fine, but gets hot pretty fast so i have not ran it more then 1 or 2 min.<br> Been hearing a lot about the o-ring at the top of the water tube, and likley I need to replace thatas well, but i cant even get flow with just the foot in the test tank!<br> PLEASE HELLLLP motor is a Evinrude 1996 model E10RELEDD 9.9 remote electric start.