Need AQ130C

[snitewolf]

Anyone have a good running AQ1

Anyone have a good running AQ130C that they are looking to sell within reasonable distance to Detroit metro area?? I need it for a '75 20ft Bayliner. figured it gonna be alot cheaper that rebuilding current one.

 

[crabbie72]

"If you are not going to rebui

"If you are not going to rebuild your current one, I really am in need of a connecting rod. I would be willing to buy one of yours.
Thanks,
Dave"

 

[cbdinak]

"DAVE,
do you know if all the

"DAVE,
do you know if all the aq's connecting rods are the same?
if so, i have quite a few!!"

 

[crabbie72]

I believe All of the b20's

I believe All of the b20's are the same. What aq did they come from? And what year if you know. Thanks for helping.
dave

 

[el_pescador]

"David, not all the AQ130s wer

"David, not all the AQ130s were created equal. Earlier versions had pistons with 22 mm wrist pins and later versions had 24 mm wrist pins. Therefore, they used different types of con rods.

Check this:

http://www.marineengine.com/discus/messages/12487/115363.shtml"

 

[txny13]

i have rods and pistons for th

i have rods and pistons for the b20 in the 24mm wrist pin size if needed

 

[crabbie72]

"I need a 24mm, John I emailed

"I need a 24mm, John I emailed you. Maybe I can still get the boat in by summer. I had almost given up.
Dave"

 

[el_pescador]

"Dave, if thigs go "really

"Dave, if thigs go "really bad", you can also consider installing a complete OHC engine (Aq131, AQ140, AQ151, AQ125, etc). They are FWC and they are somewhat newer than the B20. Just a thought."

 

[crabbie72]

"El,
I considered that, I hav

"El,
I considered that, I have twin aq130c's, I even found a guy that had two 125's, but I think I would be going down in hp, and it seemed like a lot of work. That was before I started searching for parts for the 130. But I am almost there, just need a connecting rod and I'm done. Its been a really learning experience for me, rebuilding the engine. I can now visualize how everything works. And this time I will keep a closer eye on the oil. The old one had a small pinhole leak in the oil pan, someone had epoxied a piece of metal to it. Didn't work though."

 

[txny13]

i lost your email add butt i s

i lost your email add butt i send that b 20 24mm rod and piston to you good luck