I have fixed the lower gear case so it doesn't leak. Now the motor is leaving large globs of oil water mix when I run it in a test tank. Where is the oil coming from and how do I clean up the discharged water/oil mix. I have added soap to the test tank is hopes of cleaning out the source of the oil to no avail. I get lots of bubbles but it doesn't solve the problem. I checked the compression and it's 90 over 88psi. This is a 2 cycle motor. Could there be enough oil blowing by the piston rings to cause the mix? If not where is the oil coming from. I don't want to take itout to a lake because of the discharge. Any ideas?