I've had trouble with the floats sticking after running the carbs dry at the end of the day. Based on what I've seen here on site, I'll add stabil to gas. I can't get the center carb float free with tapping. Any other tricks?
While looking at the carb parts diagram, I noticed a "Main Nozzel" that I don't recall seeing when I cleaned the carbs. Is this part pressed in or should I have seen it when removing the main jet. I purchased this motor used and don't want to make any assumptions about past service. It's part 3L9-032520.
Thanks,
Mark
While looking at the carb parts diagram, I noticed a "Main Nozzel" that I don't recall seeing when I cleaned the carbs. Is this part pressed in or should I have seen it when removing the main jet. I purchased this motor used and don't want to make any assumptions about past service. It's part 3L9-032520.
Thanks,
Mark