MarineEngine.com does not offer troubleshooting assistance or repair advice by email or by telephone.
You are invited to join our public Boat Repair Forum to seek assistance from other members.
You may also visit the Boat Motor Manuals section of our site to obtain a service manual.
Like slow cruiser said, cap off the circuits that are no longer going to be used.Going to install one wire alternator on starboard LM 318. What happens to extra wires? Any wiring needed for volt meter? Thanks, Stuski
Jack, I'm not certain, but I believe that the Chrysler alternators have always required the external voltage regulator.If the original Chrysler can be converted to one wire will work the same way ?
Jeff, I've been using the Delco 10si for years, and I've installed quite a few of them.A
PS: One warning on one wires: If you do a LOT of dead low speed running (in No Wake Zones) these are not for you. One has to blip the throttle to get them to initially charge, and running along at idle speed often causes them to stop charging (until the throttle is blipped again).