Johnson K40

[mikek40]

"Inherited a 1928 Johnson K-40

"Inherited a 1928 Johnson K-40. Before I invest $100+ in manuals I need to know that I can get parts. For sure I need float bowl cover and hot air tube for carb and gas tank/shroud. Where can I get these parts? Also, anyone know what cylinder compression should be, ignition points gap and fuel mix ratio?"

 

[Cliff C]

I have a terrific line of omc

I have a terrific line of omc parts but seldom have parts for anything older that 49

 

[mikek40]

"Cliff, Thanks for your respon

"Cliff, Thanks for your response but any ideas where I can find these parts?"

 

[Cliff C]

"I will suggest trying to look

"I will suggest trying to look on oldmarineengine.com
or http://www.aomci.org/ and ask around their good luck if you have apart number i can try and cross it"

 

[mikek40]

"Cliff, The actual parts I nee

"Cliff, The actual parts I need are the complete gas tank assembly (p/n 16-111) and the complete steering handle (p/n 18-183) Part #'s are from original Johnson Parts Catalog. I made a float bowl cover and breather tube so don't need those now. Can you help or direct me to someone who can? Thanks"

 

[mikek40]

"Anyone know what point gap sh

"Anyone know what point gap should be for 1928 Johnson K40, S/N 90935, and also where to position the retard/advance ignition plate to start with and why this plate has to be moved at all once you get the ignition timing in about the right place? Seems to be a very wide range of motion for this and I don't know why."

 

[Cliff C]

Unfortunately those parts do n

Unfortunately those parts do not cross or do not have a interchange number but you may find them on the link above

 

[mikek40]

"Cliff, What link are you refe

"Cliff, What link are you referring to?"

 

[Cliff C]

"[url=""]http://www.aomci.org/

"http://www.aomci.org/
or
oldmarineengine.com"