Logo
FULL SITE MENU

Johno 1989 110HP 2 Stroke ReStarting Issues

M

mr_johnson

Regular Contributor
"Hi Team,

Whenever I want t

"Hi Team,

Whenever I want to restart my outboard after say stopping at an island or after a stoppage for a while, it will not restart.

I am following the manual instructions without avail. SOmeone has stated the float in carbies need adjusting - If true how?

If not, what now?

I do have two carbie kits ready to go in..

I have de-carbed my outboard.

HELP??
Cameron"
 
"What is Your starting problem

"What is Your starting problem?
If the engine gets 'wet' and need a lot of throtle to vent out before start, the most probable reason is leaking float-valves (part of the carb kit)."
 
Thnaks Moreton.

I have to r

Thnaks Moreton.

I have to remove the fuel line and then crank and then reconnect fuell line and off i go..

This happens everytime.

What is the process to install these carbie kits/floats?

What special tools do i need?

Cam
 
"No special tools needed, what

"No special tools needed, whatch out for the float.
Holding carb-body upside down, it should be paralell to the body.(check when dismantling to give a refference).
Be sure to make a good clean everywhere, use compressed air to blow out."
 
Back
Top