Am I looking at something wro
Am I looking at something wrong here? I am working on my brothers 1993 70 h/p evenrude.VE70TLETS
It blew a head gasket and I was replacing it and cleaned the carbs good.
These carbs have high speed jets in the bottom with idle jets in the plastic top.
The jets in in the high speed hole are 53D
The jets in the top are 55D. am I looking at this wrong or is this right.
There was several service bulletins out on this motor and one said to change high speed to 54D.
It has a low idle sneeze si I ordered a whole kit for all three carbs and was wondering if I need to go ahead and change the jets.
I did all the new upgrades that S/B were put out on it because they were looked at but the new jets and the heat sensor was never replaced.
Am I looking at something wrong here? I am working on my brothers 1993 70 h/p evenrude.VE70TLETS
It blew a head gasket and I was replacing it and cleaned the carbs good.
These carbs have high speed jets in the bottom with idle jets in the plastic top.
The jets in in the high speed hole are 53D
The jets in the top are 55D. am I looking at this wrong or is this right.
There was several service bulletins out on this motor and one said to change high speed to 54D.
It has a low idle sneeze si I ordered a whole kit for all three carbs and was wondering if I need to go ahead and change the jets.
I did all the new upgrades that S/B were put out on it because they were looked at but the new jets and the heat sensor was never replaced.