Logo
FULL SITE MENU

Honda BF 50a BAZL 1017990 carberator float stuck

B

bvwbmo

New member
Is there any easy way to clean

Is there any easy way to clean these carbs without taking them apart? Gas is spewing all over the place on two of the three carbs..the valve set/float seems to be stuck....Will a carb cleaner work? What screw set do I open to clean with a carb cleaner?
thanks
bvwbmo
 
I would like to overhaul the

I would like to overhaul the carbs on my BF50A I have the Seloc manual but it is not specific enough for me. is there anywhere that I can get detailed procedure on rebuilding the carbs?
 
"ha

have fun, u need good s

"ha

have fun, u need good screwdrivers
ultra sonic cleaner
a carb sync

BUY all new parts, do not re-use anything

runs around $40 per carb!"
 
"...carb cleaner from Canadian

"...carb cleaner from Canadian Tire to clean out the shellac (make sure it does not contact the rubber parts )...cue tips,needles,air compressor to blow out the holes and a few hours of your time...I did not need to replace one single part it was all stickey shellac and the cleaning out of holes (the motor is a 1996 50 hp with 3 carbs)....thought I might had to change a jet on the float...The Seloc manual is very useful ...that with a bit of comment sense should more than be enought....good luck...give it a shot and if it doesn't work then take it to a dealer....the problem is the gas.. make sure you put an additive in your gas...ie OMC carbon guard..."
 
Back
Top