Logo
FULL SITE MENU

Help runs but no go

"Unless you already have done

"Unless you already have done these:

1.Check compression

2.Check spark,

you should start there. If you know that those are okay, you may have a clogged jet or two in the carbs.

You probably have a shift interrupt switch. It is possible that could be the problem if it is there."
 
"You can disconnect it easily.

"You can disconnect it easily. Just unplug it. It would be on the shift linkage, starboard side of engine."
 
ok i found out that it was the

ok i found out that it was the safty heat sensor making the motor run in SLOW mode if un plug it it runs fine but if i plug it in it doesnt. even when the motor is cold. will it hurt to leave it unpluged or do i need to break down and spend the $$$
 
"If you compare the cost of th

"If you compare the cost of the sensor to a rebuilt engine, I think it will look like a bargain."
 
"Something is not right here.

"Something is not right here. I think you may have mis-diagnosed this.
Plugging or unplugging the temp sensors will not cause the engine to shut off when put in gear. This is the description you gave in your original post.
SLOW mode kicks in at 2500 rpm, only when the engine is overheating, so again, your first post says nothing about engine problems at 2500....

I would look at your diagnosis again....something's not right."
 
Back
Top