help!! how to get ball bearings back in on 9.9 evinrude prop shaft/gear box

[evinnice]

I am doing a complete seal replacement on a old 1978 evinrude 9.9 outboard and I accidently pulled the prop shaft all the way out when I was taking out the bearing carrier and two ball bearings and the spring fell out . I know where they go but I have no idea how to get them back in. on the attached image they are numbers 10 and 11

 

[galamb]

Try posting on the over on the Johnson/Evinrude repair page - there is a few OMC master techs over there that will help you out.