Forcebwitu
New member
Hello! Just joined after reading all the posting rules, and searching for my question I now hoave two problems! LOL
1) Is there a member intro on this forum? I kinda think it would be polite..if not ok.
And my reason for joining..
My engine is in good shape, always been cared for by the O. owner..I just bought it about6 months ago. Runs great, and looks great.
My problem comes from the fact I have cooling problems. I replaced the impeller and housing. And also head gasket because she got so hot one day she split the oringinal one. But the other gasket on the head the outer one...I couldnt find a replacement for that cause the frigging thing can not be located. So I used some RTV so I could seal it up.
My problem is, when i am chugging along slwoly or at idle, she pumps toms of water. But as soon as I start her going down the lake on plane, or even above half throttle, she willstop pumping water and I see steam flying out of the exhaust with force! Almost looks like a friggin steam cleaning machine. I know the lines are clear, I know the impeller is brand new as is the housing...What in the heck could be causing this? Thanks!
1) Is there a member intro on this forum? I kinda think it would be polite..if not ok.
And my reason for joining..
My engine is in good shape, always been cared for by the O. owner..I just bought it about6 months ago. Runs great, and looks great.
My problem comes from the fact I have cooling problems. I replaced the impeller and housing. And also head gasket because she got so hot one day she split the oringinal one. But the other gasket on the head the outer one...I couldnt find a replacement for that cause the frigging thing can not be located. So I used some RTV so I could seal it up.
My problem is, when i am chugging along slwoly or at idle, she pumps toms of water. But as soon as I start her going down the lake on plane, or even above half throttle, she willstop pumping water and I see steam flying out of the exhaust with force! Almost looks like a friggin steam cleaning machine. I know the lines are clear, I know the impeller is brand new as is the housing...What in the heck could be causing this? Thanks!