"I am going to try to do the f
"I am going to try to do the fuel injector timing this weekend on my MD6A. Can anyone tell me where the marks are on the flywheel and block? I have looked for these marks and can not find them.
Also, It says I need to see the valves rock, so I need to remove the valve cover?
Thanks,
groundhog
ps. below is copied from the shop manual and mentions the marks I am referring to.
75. Adjusting the BOSCH injection pump
a. Turn over the engine until the valves in cylinder
No. 2 “rock’. Continue to turn over the engine in
the normal direction of rotation until marking 10
on flywheel coincides with the marking on the
block.
b. Remove the pump inspection cover and check
that the marking (1) coincides exactly with the
pointer (2). Adjustments are made by slackening
the pump securing nuts and turning the pump.
c. Tighten the nuts.
d. Check the setting by turning over the engine 1/4
turn in the opposite direction of rotation, then
back again to the “10,’ marking on the flywheel.
Check that the marking (1) and the pointer (2)
still coincide.
e. Fit the inspection cover with the rubber gasket."
"I am going to try to do the fuel injector timing this weekend on my MD6A. Can anyone tell me where the marks are on the flywheel and block? I have looked for these marks and can not find them.
Also, It says I need to see the valves rock, so I need to remove the valve cover?
Thanks,
groundhog
ps. below is copied from the shop manual and mentions the marks I am referring to.
75. Adjusting the BOSCH injection pump
a. Turn over the engine until the valves in cylinder
No. 2 “rock’. Continue to turn over the engine in
the normal direction of rotation until marking 10
on flywheel coincides with the marking on the
block.
b. Remove the pump inspection cover and check
that the marking (1) coincides exactly with the
pointer (2). Adjustments are made by slackening
the pump securing nuts and turning the pump.
c. Tighten the nuts.
d. Check the setting by turning over the engine 1/4
turn in the opposite direction of rotation, then
back again to the “10,’ marking on the flywheel.
Check that the marking (1) and the pointer (2)
still coincide.
e. Fit the inspection cover with the rubber gasket."