Logo
FULL SITE MENU

Evinrude 150 HP

M

mwtech

New member
"Hello everyone; I hope that s

"Hello everyone; I hope that someone on this board can help me out. Let me start out by saying that I have absolutely no experience with boat motors. I have inherited a 1985 150HP Evinrude outboard motor.It has trim and tilt, electric start and a 20" shaft (according to the model number). It has not run for about 10 years, but was running fine at that time. I don't know how many hours the engine has on it, but I suspect not too many. It has all of the control linkages and cables. I would like to sell the motor, but I have no idea what it might be worth.
Any help would be appreciated.
Thanks,
Bob"
 
"altho very thirsty,..that,is

"altho very thirsty,..that,is a great pwrhouse..now,after sitting so long,..it needs to be checked out...then,quite a bit of maintenence,will absolutely ,need to be done..depending on ur area,will set the repair bill,and value,as well as overall condition."
 
"At a minimum, the gearlube sh

"At a minimum, the gearlube should be changed, and the carburetors will require removing, cleaning, and rebuilding.

Check the compression, and with the spark plugs removed.... check the spark which should jump a 7/16" gap.

Thousands of parts in my remaining stock. Not able to list them all. Let me know what you need and I'll look it up for you. Visit my eBay store at:

http://stores.ebay.com/Evinrude-Johnson-Outboard-Parts-etc?refid=store"
 
Back
Top