Easy question for u but not me. (shift interrupt switch)

[Pbdy Jr]

Im trying to figure out my no spark problem still. New coil, new electronic ignition. New rotor. New wires. No spark. Is it possible i have a switch interrupt switch that i overlooked wiring to therefore no spark? Should I disconnect electronic ignition and try the points system again? Any advice?

 

[kghost]

The interuptor switch has two wires comming off it.

one goes to ground, the other goes to the neg side of the coil (typically).

find the wire going to the coil and remove it, also remove the grey wire, this goes to the tachometer. If a tach is bad it can kill the ignition.