Controll box tach wireing

[cedargal]

I just installed a new merc controll box and I am trying to figure out what the 4 wires are for? They are green with a white stripe,blue with a white stripe,red and brown
Thanks

http://i948.photobucket.com/albums/ad326/albernifisher/007.jpg

** Not sure if I have the colors right so I attached a picture.

 

[fastjeff]

As mein Komarade Wolfgang would say, "Was engine ist das?"

Jeff

 

[cedargal]

The motor is a 98 merc 200 2 stroke

 

[galamb]

The red (hot power) connects to both the tee (red wire) on the keyswitch which then goes up to feed the red wire on the tilt switch and the red wire feed from the harness.

The blue/white connects to the blue wire on the tilt switch, likewise, the green/white goes to the green wire on the tilt. (the red wire gives the switch it's power, the green and blue send the power back to the appropriate relay for the up and down).

Of those I am certain.

The brown, which I can't find on the pile of wiring diagrams I have for the controls, I "believe" is for the warning horn - but seem to remember it as being a brown/white wire, not solid brown - so I will defer that one...