"As many of you may have read
"As many of you may have read my other post, I rebuilt my carbs last weekend. And had gas dripping out of the brass bb on the float bowl. But thanks to jwbmarine I was able to fix that problem with his little trick.
Now I have another problem. When I prim the bulb it never gets real hard. And I can continue to squeeze the bulb. And of coarse the two bottom carbs has gas coming out the throats. I pulled them off and adjusted the float again according to the service manual. But still not shutting the gas flow off. Is there something I am over looking? I have the float parallel with the bottom of the carb when held upside down. Should I adjust the float so its higher then parallel when held upside down?
Thanks,
Robert"
"As many of you may have read my other post, I rebuilt my carbs last weekend. And had gas dripping out of the brass bb on the float bowl. But thanks to jwbmarine I was able to fix that problem with his little trick.
Now I have another problem. When I prim the bulb it never gets real hard. And I can continue to squeeze the bulb. And of coarse the two bottom carbs has gas coming out the throats. I pulled them off and adjusted the float again according to the service manual. But still not shutting the gas flow off. Is there something I am over looking? I have the float parallel with the bottom of the carb when held upside down. Should I adjust the float so its higher then parallel when held upside down?
Thanks,
Robert"