Logo
FULL SITE MENU

BF200 Lower Unit

K

kshiver

New member
"I pulled a bone head move on

"I pulled a bone head move on my BF200. I was cruzing at about 4000 rpm and went to pull the motor out of gear, by acident I pulled into rev. Is this something that I should have looked at or anything I should lookout/listen for. It seams to work fine but did break the tork hub which I replaced. I go off shore alot and dont want to be stranded. Any advice, other than dont do that again? Thanks. Ken"
 
"I checked the lower unit oil,

"I checked the lower unit oil, no chunks just very small slivers. The motor only has about 70 hrs on it. Would this be normal. If no chunks do you think its okay.
Thank you very much for your reply. From reading the other post I respect your opinion.
Thanks again, Ken"
 
Back
Top